华为9306交换机为何无法将PBR添加到端口

Question

H3C的交换机是配置好了 policy based route 以及acl之后 进入端口，然后使用命令ip policy based route XXXX 就可以将PBR添加到端口上。
但是huawei 9306交换配置好了 PBR 和acl之后就无法进入到端口没有ip policy based route XXXX ，并且进入到该端口所在的default valnif中 也添加不了 这是为什么呢？
VRP (R) software, Version 5.70 (S9300 V100R003C00SPC200)

Answer 1

配置ACL规则

# 在Switch上创建编码为3001、3002的高级ACL，规则分别为允许IP优先级4、5、6、7和允许IP优先级0、1、2、3的报文通过。

[Switch] acl 3001
[Switch-acl-adv-3001] rule permit ip precedence 0
[Switch-acl-adv-3001] rule permit ip precedence 1
[Switch-acl-adv-3001] rule permit ip precedence 2
[Switch-acl-adv-3001] rule permit ip precedence 3
[Switch-acl-adv-3001] quit
[Switch] acl 3002
[Switch-acl-adv-3002] rule permit ip precedence 4
[Switch-acl-adv-3002] rule permit ip precedence 5
[Switch-acl-adv-3002] rule permit ip precedence 6
[Switch-acl-adv-3002] rule permit ip precedence 7
[Switch-acl-adv-3002] quit
配置流分类

在Switch上创建流分类c1、c2，匹配规则分别为ACL 3001和ACL 3002。

[Switch] traffic classifier c1
[Switch-classifier-c1] if-match acl 3001
[Switch-classifier-c1] quit
[Switch] traffic classifier c2
[Switch-classifier-c2] if-match acl 3002
[Switch-classifier-c2] quit

配置流行为

# 在Switch上创建流行为b1、b2，并分别指定重定向到网段20.20.20.1/24和20.20.30.1/24的动作。

[Switch] traffic behavior b1
[Switch-behavior-b1] redirect ip-nexthop 20.20.20.1
[Switch-behavior-b1] quit
[Switch] traffic behavior b2
[Switch-behavior-b2] redirect ip-nexthop 20.20.30.1
[Switch-behavior-b2] quit

配置流策略并应用到接口上

# 在Switch上创建流策略p1，将流分类和对应的流行为进行绑定。

[Switch] traffic policy p1
[Switch-trafficpolicy-p1] classifier c1 behavior b1
[Switch-trafficpolicy-p1] classifier c2 behavior b2
[Switch-trafficpolicy-p1] quit
# 将流策略p1应用到接口1/0/1。

[Switch] interface gigabitethernet1/0/1
[Switch-GigabitEthernet1/0/1] traffic-policy p1 inbound
[Switch-GigabitEthernet1/0/1] quit
[Switch] quit

请参考!

Answer 2

93里面只能用traffic-policy来做了...配置都一样，只不过换了种方式而已本回答被提问者采纳